Unfortunately, you will not be able to achieve a good result after one or two layers of putty. After the joint compound dries, it only requires a light sanding. Check to make sure the hole is filled flat with joint compound.
There Are Three Main Divisions Of Putty:
Its price will be lower if you buy large volumes. You should definitely use a finishing putty to prevent the paint or glue from absorbing into the drywall. Before cutting, check the hole for electrical wires.
Mud On The Knife Lubricates It So It Won't Pull At The Tape And Thoroughly Moistens The Tape For Good Adhesion.
Be sure the center of the tape is as even as possible with the seam between the drywall boards. After applying a layer of putty, a sickle is attached and once again smeared. Without quality putty joints it is impossible to achieve an overall good result.
Do Not Forget That Before Applying The Finishing Layer All Seams And Other Elements Should Be As Smooth As Possible.
So it is undesirable to skip the primer. Trace around the gypsum on the wall. Wet the edges of the excess paper on your patch, and the edges of the sheetrock on both the patch and the wall hole, (this will help it bond later).
When You Putty Drywall Putty With Your Own Hands, After It Is Completely Dry You Will Need To Carefully Polish The Surface.
Unfortunately, you will not be able to achieve a good result after one or two layers of putty. Typically, they are attached to studs. Holding the knife at an angle to the drywall with the mudded side facing the wall, press the front edge of the knife against the wall and draw it across the hole.
The Surface Is Primed And Drying Time Is Given.
Putty of drywall joints is carried out even before applying the composition to the main surface of the material. In a small packaging, it's just more expensive. Spread out the glob of putty along the blade of the large trowel so that it reaches nearly from end to end.
